×

Cleaning the Resin Tank after a Failed Print

For successful prints, it is essential that the Form 1+ resin tank remains clean and free of debris. Occasionally, a failed print will leave small, partially cured pieces of resin floating in the tank, or hard cured resin stuck to the PDMS in the base of the tank. It is good practice to inspect and clean the tank after every print.

1. Inspect the resin tank

Tip

Using the Form Finish Kit scraper, very gently scrape across the PDMS layer with the blade at a low shallow angle.


2. Position scraper underneath cured resin


3. Remove the cured resin

Contact Support

Questions? Get in touch.

×