FUSE 1 SLS MATERIALS

Nylon Powders

3D print production-ready, end-use parts on the Fuse 1 with our family of Nylon Powders. Our materials, hardware, and software are developed and validated together to deliver peak performance while optimizing cost per part.

 

Nylon 12

Nylon 12 Powder

A Material That Does It All

Balancing strength and detail, Nylon 12 Powder is a highly capable material for both functional prototyping and end-use production of complex assemblies and durable parts with high environmental stability. Our Nylon 12 Powder is specifically developed for use on the Fuse 1.

 

Tensile Strength
50MPa

Elongation AT BREAK (X/Y)
11%

Refresh Rate
30%

Nylon 12 Powder is ideal for:

High performance prototyping
Small batch manufacturing
Permanent jigs, fixtures, and tooling
Biocompatible, sterilizable parts*
Download Technical Data Sheet

 

* Material properties may vary based on part design and manufacturing practices. It is the manufacturer’s responsibility to validate the suitability of the printed parts for the intended use.

Nylon 11

Nylon 11 Powder

High Performance, High Impact

For highly ductile, robust parts, Nylon 11 Powder is our higher performance nylon material for functional prototyping and small batch production. Compared to Nylon 12 Powder, our Nylon 11 Powder is more flexible, less brittle, and better at printing thin walls.

Tensile Strength
49MPa

Elongation AT BREAK (X/Y)
40%

Refresh Rate
50%

Nylon 11 Powder is ideal for:

Impact-resistant prototypes, jigs, and fixtures
Thin-walled ducts and enclosures
Snaps, clips, and hinges
Orthotics and prosthetics*
Download Technical Data Sheet

 

* Material properties may vary based on part design and manufacturing practices. It is the manufacturer’s responsibility to validate the suitability of the printed parts for the intended use.

Water bottle holder designed by Albatross Bikes. Ankle foot orthosis designed by Prosthesia.

Make the most of your material with simple, efficient powder recycling.

What is refresh rate?

The ability of an SLS 3D printer to print with a mix of new and recycled powder. The powder refresh rate is the minimum ratio of fresh powder required to print.

30%

Refresh Rate

70%

Recycled Powder

How it works

Just set the desired refresh rate on the touchscreen and the Fuse Sift powder recovery station will automatically mix and dose powder to be reused in future prints.

In automotive, it is important that you deliver the highest possible quality at the best price possible. At the moment, anything under 10,000 parts per year could be printed in SLS. With the Fuse 1, we have a very capable product, at a very competitive price.

Christian Kleylein, Technologist for AM Polymer Series Manufacturing, Brose

Sample Part

Request a free sample part printed on the Fuse 1.

Request a Sample Part

A New Wave of Independent Manufacturing Starts Now

 

Rethink product development and take control of your own manufacturing. Configure your Fuse 1 setup today.