Essential Steps for Firing Success
Ceramic Resin is a Form X product. This material is more complex to work with than other Formlabs products and requires extra steps and additional experimentation for successful printing. It may take a few iterations to create a final fired part that meets your specifications.
Make sure to read the Usage Guide in full before using this material.
Ceramic Resin requires designing within specific constraints for successful printing and firing. Start small, follow the usage guidelines, and experiment.
Sand your build platform to increase print adherence, shake the cartridge to mix the material, and clear the bite valve.
Scale your parts in PreForm to accommodate for shrinkage during firing. Send your design to the Form 2 and press print.
Wash your prints in isopropyl alcohol (IPA) and remove supports (no post-curing necessary). Ensure that parts are completely dry before firing.
Fire your part in an actively ventilated kiln that fires to at least cone 8 to burn out the photopolymer from the material and create a fully ceramic final part. Parts will shrink by around 15% in XY and 29% in Z during firing.
If desired, apply a glaze of your choosing, following the manufacturer’s instructions.